CS range pumps used in food industries

Seepex pumps of module range CS are used primarily in the food, pharmaceutics, cosmetics and chemical industries.

The pumps with CIP (Cleaning In Place) and SIP (Sterilisation In Place) capabilities meet the highest requirements for gentle handling, hygiene, cleaning and sterilisation and comply with the regulations of the 3-A Sanitary Standards of the USA and the EHEDG directives.

The pumps are service friendly due to plug-in connections between the rotating unit and drive, dismantling/mounting can be done without special tools.

Optimised pump housings without clearance volume prevent product deposits.

The high-quality surfaces of the housing walls and the rotating inside parts simplify residual-free cleaning.

Easily mountable joints increase the service-friendliness.

Proven mechanical seals adapted to the respective application provide for hygienic shaft sealing.

Stator material and secondary seals with FDA approval guarantee high product safety.

CIP rinsing with high flow rates in the suction casing provide for residual-free and bacteria-free cleaning.

SIP with superheated steam is also possible during cycled operation of the pump.

The pumps of the BCSO range are equipped with open aseptic joints that can be cleaned without leaving residues through CIP continuous cleaning.

They meet highest demands on hygienic cleanliness and on corrosion and wear resistance.

The open-fork joint features an especially shaped coupling rod and the rotor or plug-in shaft head.

Apart from that, it is made up of only two components - the bolt and the circlip.

For higher pressures and conveying capacities, Seepex additionally offers a newly developed, open-pin joint.

Service work can be performed easily and rapidly without the need for special tools.

Just like all the pumps of the BCSO range, these joint designs comply with the regulations of the 3A-Sanitary Standards of the USA and the EHEDG directives.

The pumps of the BCSB range differ from those of range BCSO in their joint design.

The BCSB range is equipped with the proven, closed-pin joints from the Seepex pumps of the BN/NS ranges.

These cost-efficient and wear-resistant pin joints are filled with a special grease approved for the food sector and sealed through a resilient universal joint sleeve and holding bands.

They are suited for use with abrasive conveying media and high operating pressures.

The BTCS range features a feed hopper with a cylindrical/conical compression zone.

Highly viscous conveying media with a low degree of flowability are fed to the conveying elements rotor and stator through the auger feed screw on the coupling rod.

Optimum filling of the conveying chamber is achieved through the priming pressure generated in the compression zone.

The pumps of the BTCS range are optionally equipped with the open, service-friendly joints or with the proven, closed-pin joints.

Back to top