Product category:
Power supplies and plant cabling
News Release from: E-T-A Circuit Breakers | Subject: ESX10
Edited by the Processingtalk Editorial
Team on 21 February 2008
Overcurrent protection in automation
applications
E-T-A Circuit Breakers has introduced a new DIN-rail mounted version of its compact ESX10 electronic overcurrent protection product for automation applications
Designed to reduce costly downtime and danger to personnel on production lines, the new ESX10-T is ready for direct rail mounting, singly or in groups Single or group signalisation is quickly attainable
This article was originally published on Processingtalk on 14 Feb 2006 at 8.00am (UK)
Related stories
New electronic circuit protector for SMPS loads
E-T-A Circuit Breakers has extended its range of electronic overcurrent protection products for automation applications with the new ESX10, which ensures selective disconnection of SMPS loads
ATEX100 approvals gained for thermal flowmeter
E-T-A Circuit Breakers has obtained the very latest stringent ATEX 100a approvals for its microcontroller operated FM 1-Ex flow meter, with the digital display authorised for Zone 2 operation
The type ESX10 Electronic Circuit Breaker provides electronic over-current protection according to UL2367 for 24V DC control circuits and load currents from 1A to 12A: in the event of overload or a short circuit, the faulty load will be disconnected electronically by means of a Mosfet in the output circuit of the protector.
It ensures selective disconnection of 24V DC switch-mode power supply (SMPS) loads while optimally matching the application requirements.
The E-T-A ESX10 provides active current limitation to 1.8 or 1.5 times its rated current.
Further reading
All-in-one remote power controller from E-T-A
The new E-T-A Circuit Breakers remote power controller combines the capability of an electronic switching relay with self-limiting characteristics, and optimised over-current protection
Plug and play water flow measurement
Used in combination with E-T-A monitoring heads and adapters, the meter offers direct readouts of flow speed and flow volume measurement, while also providing analogue and signalling outputs
This allows capacitive loads of up to 20,000F or lamp loads to be switched on without affecting other loads on the power supply.
At the same time, this electronic active current limitation responds much faster to overload or short circuit conditions than switch-mode power supplies: the ESX10 will shutdown electronically a single faulty output, while allowing all other load circuits connected to the same SMPS to continue working as normal.
The E-T-A ESX10-T is just 12.5mm wide and can be mounted directly on a DIN/EN rail.
All electrical connections are then made by means of convenient screwless terminals.
Status indication is provided by a multicolour LED plus an integral short-circuit proof status output or potential-free signal contact.
In the event of an overload or short circuit, the load circuit may be re-activated electronically via a re-set input, or by a manual ON/OFF button.
The ON/OFF button also allows manual disconnection when starting up a system or during maintenance.
For processes powered by 24V DC switch-mode power supplies without circuits protected by a device such as the ESX10, an overload in a single circuit will cause the power supply to shut down the output to all the circuits it supplies.
On recovery it may go into 'hiccup' mode.
Costly downtime, scrap and even danger to personnel may result.
Traditional protection solutions do not provide the answer.
Circuit breakers with fast operating characteristics would be likely to cause nuisance trips during current peaks and switching on of capacitive loads.
On the other hand MCBs are too slow, and neither delayed operation nor high performance circuit breakers will respond adequately in this situation to overcurrents.
The power supply will therefore switch off completely, bringing all connected loads, i.e the entire system, to a standstill. Request a free brochure from E-T-A Circuit Breakers ...
• E-T-A Circuit Breakers: contact details and other news
• Email this article to a colleague
• Register for the free Processingtalk email newsletter
• Processingtalk Home Page
Search the Pro-Talk network of sites
