Product category:
Gas and Steam Flow Measurement
News Release from: Flotech Solutions | Subject: Brooks Ar-Mite
Edited by the Processingtalk Editorial
Team on 14 April 2003
Gas and liquid low flow goes remote
The Brooks Ar-Mite range of gas and liquid low flow purgemeters is now available with a microprocessor based 4-20mA flow transmitter unit, for remote indication and control
These typically 1/4 inch NPT variable area flowmeters have seven models to cover full scale flows of between 1 and 100 litre/hour water, or 40 ln/h to 3.0 normal cubic metres per hour air, with an accuracy of Class 2.5 to VDE/VDI 3513 Units are pre-calibrated to suit site conditions and fluids, and operate over a 10:1 flow range, but can be re-programmed on site if needed
This article was originally published on Processingtalk on 24 Dec 2002 at 8.00am (UK)
Related stories
Remote output for purgemeters.
The Brooks Ar-Mite range of gas and liquid low flow purgemeters is now available with a microprocessor based 4-20mA flow transmitter unit, for remote indication and control.
This significant development in remote electronic transmission of very low flow measurements results from the use of a patented magnetic sensor, using AGC techniques to monitor the position of the float inside the flow tube.
The two-wire, IP67 transmitter unit is Cenelec approved for use in hazardous areas.
MT3750 Ar-Mite models are available from Flotech Solutions, the UK Distributor for Brooks products, with stainless steel 316L or Monel wetted parts, suitable for process pressures up to 276bar and 200C.
Multi-turn flow control needle valves and flow controller accessories are also available, as are separate inductive sensor or reed switch adjustable alarms. Request a free brochure from Flotech Solutions ...
• Flotech Solutions: contact details and other news
• Email this article to a colleague
• Register for the free Processingtalk email newsletter
• Processingtalk Home Page
Search the Pro-Talk network of sites
