Product category:
Calibration Services
News Release from: Pullman instruments (UK) | Subject: Airflow Anemometer Calibration Rig
Edited by the Processingtalk Editorial
Team on 07 July 2004
New airflow calibration facility in
Yorkshire
Pullman Instruments (UK) have installed an Airflow Anemometer Calibration Rig, to offer the rapid and accurate calibration of anemometers, manometers, pitot tubes, temperature and humidity
Pullman Instruments (UK) of Harrogate, North Yorkshire have had installed an Airflow Anemometer Calibration Rig Pullman are able to offer the rapid and accurate calibration of anemometers, manometers, pitot tubes, temperature and humidity
This article was originally published on Processingtalk on 18 Nov 2004 at 8.00am (UK)
Related stories
New wallchart simplifies IEC61508
August 2004 was the deadline for IEC 61508, the standard focusing on safety-related systems that incorporate electrical, electronic or programmable instruments: this step by step wallchart will help
The Airflow anemometer calibration rig is an open jet wind tunnel designed and built to BS 1042 specification.
Along with a master test meter we are able to set and control velocities from 0.25 to 30.5 m/sec.
The air stream is constantly monitored for turbulence and the tunnel is of a laminar design so as to keep the air stream stable and uniform.
Velocity levels are regulated using an inverter drive and the tunnel also uses sharp edge orifice plates for different ranges.
This system allows Pullman to calibrate the full range anemometers by virtually all manufactures.
Pullman Instruments (UK) Ltd are the approved service agents for Airflow Developments Limited in the north of England.
• Pullman instruments (UK): contact details and other news
• Email this article to a colleague
• Register for the free Processingtalk email newsletter
• Processingtalk Home Page
Search the Pro-Talk network of sites
