Product category:
Motors and Variable speed drives
News Release from: Renold Gears | Subject: Cloned wormwheel
Edited by the Processingtalk Editorial
Team on 22 December 2006
Cloned wormwheel is the largest from
Renold Gears
Renold Gears has manufactured the largest wormwheel in their history - by cloning a worm gear currently operating on a huge coal-pulveriser drive at a coal-fired power plant in the USA
Renold Gears has manufactured the largest wormwheel in their history - and has done so by cloning a worm gear currently operating on a huge coal-pulveriser drive at a coal-fired power plant in the USA The phosphor-bronze wheel is 2.4 metres in diameter and weighs in at just over four tons
This article was originally published on Processingtalk on 24 Jun 2003 at 8.00am (UK)
Related stories
New shaft mounted helical units from Renold Gears
Renold Gears, a business of Renold Power Transmission, has launched a breakthrough in gear design with its "new generation" mounted helical gear units, the SMXtra
Renold Gears solve Glasgow lift problems
High rise block lifts, with Radicon units condemned due to excessive backlash, were given New for Old treatment and replaced with the fully interchangeable WM series wormgear units from Renold Gears
The coal pulveriser at the power plant grinds the coal to fine dust before it is mixed with warm air and blown into a furnace where it ignites.
The wormwheel was manufactured as a replacement for one that was coming to the end of its working life, but because Renold didn't manufacture the original the company had to "reverse engineer" the tooth form of the gears in the USA for virtual cloning at its factory in Milnrow.
In a worm and wheel set the teeth must mesh to give a perfect contact, and the precise measurements of the profile of the teeth are critical.
Renold Gears had to ensure that the worm wheel manufactured at its factory in Milnrow would mesh precisely with the worm gear at the power plant in the USA.
Each gear manufacturer cuts its gears to its own tooth form and without having the details of this, gears have to be copied using a very precise method of back engineering.
This was achieved by taking an exact impression of the mating wormshaft thread profile in a perfect mould known as a slug.
The slug was then couriered to the Renold Gears factory in Milnrow where it was measured using the latest co-ordinate measurement machine loaded with a unique Renolds software package.
This maps the slug precisely and creates a computer model of the original worm thread profile.
From this model Renold Gears was then able to manufacture a master worm and the tooling with which the new worm wheel could then be hobbed.
After hobbing the wheel was paired with the master and adjusted to get the optimum profile in order to create a perfect clone of the original worm wheel in the USA.
Stephen Whitehead, Renold Gears Sales Director, and responsible for Holroyd gears, said: 'This is a major achievement for the company and we are all delighted to have been involved in this exciting project.
It's an example of British engineering at its best and shows that the world's blue chip companies are still turning to the UK when they require high degrees of engineering skill and accuracy'.
• Renold Gears: contact details and other news
• Email this article to a colleague
• Register for the free Processingtalk email newsletter
• Processingtalk Home Page
Search the Pro-Talk network of sites
