Product category:
Welding, cutting and adhesive bonding
News Release from: Wilkinson Star | Subject: Plasma Cut 26i
Edited by the Processingtalk Editorial
Team on 31 May 2007
New plasma cutter with in-built
compressor
Wilkinson Star has launched Plasma Cut 26i, a NEW single phase 50/60Hz, 3,7kVA, 16A fuse, IGBT based inverter plasma cutting machine with an integrated industrial compressor
The Plasma Cut 26i, which is generator compatible, has a clean cutting capacity up to 6mm and severance cutting up to 8mm, cutting any metal or perforated laminated sheet and is suitable for a wide industrial usage including, general fabrication, installation and maintenance teams, blacksmiths, automotive body repairers, agricultural engineers as well as plumbers and the building industry The current range is 10-25A with a 50% duty cycle at 40C of 20A and a 35% duty cycle at 40C of 25A
This article was originally published on Processingtalk on 4 Sep 2006 at 8.00am (UK)
Related stories
Multi-process portable welder
The Cebora Tri Star MIG1635/M is a new low cost, single phase 160A multi-process welding power source using inverter technology from Wilkinson Star
Features of the equipment are its in built air compressor (for use when compressed air is not available), digital electronic control, a pilot arc on the torch, with a safety switch so that the torch cannot be struck accidentally, over/under voltage protection and a control panel that is protected against accidental impacts.
It is lightweight at 18,5 kgs, small in size - 540mm (d) x 220mm (w) x 425mm (h), CE marked, and meets EN60974-1, IEC 60974-10 and EN60974-7 standards.
Wilkinson Star is the Worsley, Manchester based industrial equipment supplier and sole UK representative for welding equipment manufacturer CEA SpA Italy.
• Wilkinson Star: contact details and other news
• Email this article to a colleague
• Register for the free Processingtalk email newsletter
• Processingtalk Home Page
